- #CPU FAN CONTROL INSTALL#
- #CPU FAN CONTROL DRIVERS#
- #CPU FAN CONTROL MANUAL#
Unfortunately, fancontrol does not work after suspending.
#CPU FAN CONTROL INSTALL#
fancontrol can also be ran by starting/enabling rvice.įor an unofficial GUI, install fancontrol-gui AUR or fancontrol-kcm AUR.įancontrol stops working after suspend–wake cycles Users should hear system fans starting shortly after executing this command. Running FancontrolĪ properly configured setup will not output errors and will take control of the system fans. Check the rvice unit status to find out which path is the troublemaker and correct your configuration file accordingly.
hwmon0/device/temp1_input becomes hwmon0/temp1_input). Note: Temperature and fan sensor paths could change as well (usually on a kernel update) (e.g. After that, run the following to check if it detected the sensors correctly:Ĭore 0: +29.0☌ (high = +76.0☌, crit = +100.0☌) This will detect all of the sensors present and they will be used for fancontrol.
#CPU FAN CONTROL DRIVERS#
Check the official lm-sensors devices table to see if experimental drivers are available for such motherboards. Support for newer motherboards may not yet be in the Linux kernel.
isw - Fan configuration for some MSI laptops.įancontrol is a part of lm_sensors, which can be used to control the speed of CPU/case fans. fan2go - An alternative to Fancontrol independent of device-paths. #CPU FAN CONTROL MANUAL#
ASUS laptops - Configure some ASUS laptops for Fancontrol or manual control. ThinkPad laptops - Fan configuration for some ThinkPad laptops. 
Dell laptops - Alternative fan control daemon for some Dell laptops. Most suitable for latest, unsupported by Fancontrol laptops. NoteBook Fan Control (NBFC) - Cross-platform solution for laptop fan control, written in C# and works under Mono runtime. Most suitable for desktops and laptops, where fan controls are available via sysfs(5). Fancontrol (lm-sensors) - Script (written in Bash) to configure fan speeds. There are multiple working solutions for fan control for both desktops and notebooks. Here is some more information about this topic. In some cases, you will not be able to use the Fancontrol script due to incompatible cooling architecture (e.g. Some laptops have two fans for CPU and GPU, but the first fan cools down CPU and GPU at the same time, while the other one cools CPU only. Some laptops have single fan for both CPU and GPU and cools both at the same time. Note: Laptop users should be aware about how cooling system works in their hardware. 9.2.2 Alternative solution: absolute paths. 9.2 Device paths have changed in /etc/fancontrol. 9.1 Increase the fan divisor for sensors. 7.5 Fan control modes on certain TUF series laptops. 7.3 Alternative method using EC registers. 7.2 Generate configuration file with pwmconfig. 2.4 Fancontrol stops working after suspend–wake cycles.
0 kommentar(er)
